Note:
The item location is abroad. Please note that this may affect delivery conditions, shipping times, and/or the purchasing process.
The well-known GATE ASTER in the basic version for V3 gearboxes. Here is the newer version "SE"
This drop-in unit controls the firing cycle of a V3 gearbox and ensures that jams are not possible. The trigger travel can be adjusted, allowing for faster firing rates - depending on how fast the finger and the motor are...
All relevant information can be found on gatee.eu - we will not list it here again, as it should be well known. The ASTER V2 SE now has a few new features, which we will briefly outline here.
– No USB link is required for installation and configuration
– New noise-resistant trigger recognition algorithm
– Hair trigger ready to use. About 60 trigger sensitivities for the 1st mm (0.04 in) of movement
– Additional protection against interference through multilayer circuit board with EMC shielding
– Automatic pre-cocking: LOW / MID / HIGH
– Compatibility with brushless motors (“Brushless” – e.g. Warhead)
– Improved cycle detection
– Active brake (AB): Adaptive / 100% / 60% / Brushless motor / OFF
– New selection mode: SAFE – SEMI – BINARY instead of SAFE – BINARY – AUTO (only in the international version).
– The GCS app allows for firmware updates via the internet (USB link required).
As usual:
Only install if you know what you are doing!
Only install if you are aware of the legal regulations!
Do not pull on the cables, re-solder the connectors, short-circuit, submerge in water... well... everything you shouldn't do.
The set has been trimmed down by GATE in the delivery scope. The "large" instruction manual is no longer included, the patch, and the packaging is also not as nice as it once was...
(Show description in original language)
Das bekannte GATE ASTER in der Basisversion für V3 Gearboxen. Hier die neuere Version "SE"
Diese Drop-in-Unit steuert den steuert den Schusszyklus einer V3 Gearbox und sorgt dafür, dass Jams nicht möglich sind. Der Abzugsweg lässt sich einstellen und erlaubt damit schnellere Schussfolgen - je nachdem wie schnell der Finger und der Motor ist...
Alle relevanten Informationen findet man auf gatee.eu - Wir listen sie hier nicht nochmal auf, da sie hinlänglich bekannt sein dürften. Das ASTER V2 SE hat nun ein paar Neuerungen, die schreiben wir hier mal kurz rein..
– Für die Installation und Konfiguration muss kein USB-Link verwendet werden
– Neuer rauschresistenter Triggererkennungsalgorithmus
– Haartrigger sofort einsatzbereit. Etwa 60 Auslöseempfindlichkeiten für den 1. mm (0,04 in) der Bewegung
– Zusätzlicher Schutz vor Störungen durch mehrlagige Leiterplatte mit EMV-Abschirmung
– Automatisches Vorspannen („Precocking“): LOW / MID / HIGH
– Kompatibilität mit bürstenlosen Motoren („Brushless“ – z.B. Warhead)
– Verbesserte Zykluserkennung
– Aktivbremse (AB): Adaptiv / 100 % / 60 % / Bürstenloser Motor / AUS
– Neuer Wahlmodus: SAFE – SEMI – BINARY statt SAFE – BINARY – AUTO (nur in der internationalen Variante).
– Die GCS-App ermöglicht das Durchführen von Firmware-Updates über das Internet (USB-Link erforderlich).
Wie üblich:
Nur verbauen, wenn du weißt, was du tust!
Nur verbauen, wenn du die gesetzlichen Bestimmungen kennst!
Nicht an den Kabel reißen, die Stecker umlöten, kurzschließen, unter Wasser setzen... naja.. alles was man eben nicht machen sollte.
Das Set wurde von GATE im Lieferumpfang abgespeckt. Nicht mehr enthalten ist das "große" Anleitungsheft, der Patch und die Verpackung ist auch nicht mehr so schön wie sie mal war...