Achtung: Your browser is outdated. Please note that Gunfinder may not work properly in some places. You should update your browser as soon as possible. Learn more here!

GEISSELE 5.56/.223 Suppressor Alignment Gage

115.90 €
No permit required (18+)
8700 Leoben, Austria
0
ID: 10090099
This item is currently unavailable.
Shop safely with Gunfinder
Our AI-powered seller identity verification makes Gunfinder the safest marketplace online. Learn more
About the seller
Earms
Dealer

Details

Original language
German
Category
Condition
New
Location
🇦🇹 8700 Leoben, Austria
Availability
Out of stock

Freshness

This listing is based on a mirrored offer, where the listing data was synced to us from a shop, dealer, or external marketplace. Please note that temporary price discrepancies may occur due to possible delays in data transmission.
Source
Earms
Last updated
about 15 hours ago

Description

Note: The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.
The Geissele Suppressor Alignment Gage (SAG) is a precision gage used to verify the alignment of a suppressor to the bore of a firearm barrel. It is important to understand that the length of the suppressor is usually much longer than the length of the barrel / muzzle device / suppressor interface geometry. A small deviation at the mounting interface means a much larger deviation of the suppressor exit hole. The deviations from nominal can also be additive which compounds suppressor misalignment. The Geissele SAG is manufactured from hardened steel that has been ground 0.002” under nominal bore diameter. The outside diameter of the SAG is finely finished and straight to 0.001” over its length. Geissele hardens the SAG so that it will not wear by sliding exposure to abrasive powder residue, pull burrs if it slides against misaligned baffles nor allow abrasive particle to imbed into the surface of the gage. There can be a wide variation in barrel bore diameters and bore straightness. 0.002” under nominal bore diameter has been found to be the best size of the SAG that will fit most barrels. The long length of the SAG aligns the gage to the bore; it is not necessary to have a very tight fitting gage with the long length of the Geissele SAG. Specs: Approved way to verify proper suppressor alignment Precision-machined rod will show any deviation in alignment For 5.56/.223 barrels Length: 15" / 382mm MADE IN THE USA

You might also like

Top Auctions

Sponsored listings