STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU, image 1 of 3

STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU

39.90 €

No permit required (18+)

8700 Leoben, Austria

ID: 10089587

Shop safely with Gunfinder

Our AI-powered seller identity verification makes Gunfinder the safest marketplace online. Learn more

About the seller

Earms

Dealer

3,748 listings

Details

Original language

German

Category

Condition

New

Location

🇦🇹 8700 Leoben, Austria

Availability

Unknown delivery time

Freshness

This listing is based on a mirrored offer, where the listing data was synced to us from a shop, dealer, or external marketplace. Please note that temporary price discrepancies may occur due to possible delays in data transmission.

Source: Earms
Last updated: about 11 hours ago

Description

Note: The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.

The Strike Industries AR Mil-Spec Buffer Housing gives the user a cost-effective means of customization while retaining functionality. The AR-15 buffer is often an overlooked part of the gas system that is needed to properly fine-tune your specific setup. This buffer housing is machined from 6061-T6 aluminum and designed to fit Mil-Spec standard or carbine length receiver extensions/buffer tubes while also providing a level of customization. The SI AR Mil-Spec Buffer Housing is shipped without weights so that you can either replace your current housing, use existing weights or opt to purchase weights to refine the weapons gas system to your specific needs. The NBR rubber material buffer pad helps absorb impact and is secured by the included roll pin. By modulating the weight through the combination of tungsten, steel and aluminum weights, the user is given a cost-effective means of adjusting the weapons reciprocating mass, and thus the recoil experienced by the shooter with the Strike Industries AR Mil-Spec Buffer Housing. COMPATIBILITY:-14mm (0.55") diameter Mil-Spec buffer weights and spacers (maximum of 14.20mm)-Mil-Spec standard and carbine length receiver extensions/buffers NOTE:-Buffer housing only, no weights or spacers included-Due to numerous factors that take place during the anodization process, the color lines from batch to batch of a certain product may vary -LENGTH: 83.15 (with buffer pad)-WIDTH: 25.25mm (curve to curve)-HEIGHT: 24mm (flat to curved)-WEIGHT: 1.0 oz-WEIGHT W/ PKG: 1.2 ozMONTAGEVIDEOMADE IN THE USA

STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU

Earms

Details

Freshness

Description

You might also like

Buying Service

Top Auctions

Buying Service

Sponsored listings