Achtung: Your browser is outdated. Please note that Gunfinder may not work properly in some places. You should update your browser as soon as possible. Learn more here!

NECK SIZING BUSHINGS

≈ $43
Price at the dealer: £32.90. Converted at the ECB rate as of November 20, 2026.
No permit required (18+)
CV23 9LP Dunchurch, United Kingdom
0
ID: 12115247
Purchase from outside the EU: The firearm goes through an importer in your country, the dealer handles the export. How buying from Europe works
Shop safely with Gunfinder
Our AI-powered seller identity verification makes Gunfinder the safest marketplace online. Learn more
About the seller
Odos UK
Dealer

Details

Category
Condition
New
Location
🇬🇧 CV23 9LP Dunchurch, United Kingdom
Availability
In stock

Freshness

This listing is based on a mirrored offer, where the listing data was synced to us from a shop, dealer, or external marketplace. Please note that temporary price discrepancies may occur due to possible delays in data transmission.
Source
Odos UK
Last checked with the dealer
about 16 hours ago

Description

Note: The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.
Hardened stainless steel neck bushing from L.E. Wilson. Wilson makes their bushings in .001” increments. The size marked on them refers to the middle of the bushing, which is reamed with a .003” taper. Since the case neck only reaches the middle, a slightly tighter sizing can be achieved by turning the bushing over, with the markings facing toward the case (markings facing down). This is mainly an emergency step to be taken if the brass has hardened, springing back more, and will no longer hold the bullet; or for fine-tuning the sizing to provide less additional “squeeze” than using the next smaller bushing in the normal way. Made to similar specs to the Redding neck bushings. Will not interchange with Forster or RCBS dies. Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".

Similar listings