Achtung: Your browser is outdated. Please note that Gunfinder may not work properly in some places. You should update your browser as soon as possible. Learn more here!

STEEL NECK SIZING BUSHINGS

≈ $33
Price at the dealer: £24.90. Converted at the ECB rate as of November 20, 2026.
No permit required (18+)
CV23 9LP Dunchurch, United Kingdom
0
ID: 12112928
Purchase from outside the EU: The firearm goes through an importer in your country, the dealer handles the export. How buying from Europe works
Shop safely with Gunfinder
Our AI-powered seller identity verification makes Gunfinder the safest marketplace online. Learn more
About the seller
Odos UK
Dealer

Details

Category
Condition
New
Location
🇬🇧 CV23 9LP Dunchurch, United Kingdom
Availability
In stock

Freshness

This listing is based on a mirrored offer, where the listing data was synced to us from a shop, dealer, or external marketplace. Please note that temporary price discrepancies may occur due to possible delays in data transmission.
Source
Odos UK
Last checked with the dealer
about 15 hours ago

Description

Note: The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.
RCBS Steel Neck Bushings are interchangeable to let the reloader select a bushing that gives precisely the right amount of tension on the bullet when using RCBS Gold Medal Match sizing dies. Using a precisely fitted Steel Neck Bushing reduces work hardening of the case neck brass, prolonging case life and helping to improve accuracy. Self-centering for proper alignment with case neck For best results, the use of high-end brass with consistent neck thicknesses is recommended Bushings come "in-the-white" - bare steel - so traditional case lubrication is required For use ONLY with RCBS Gold Medal sizing dies RCBS recommends having neck bushings one to two sizes above and below your target diameter (see note below). RCBS Steel Neck Bushings are a small but critical component in loading extremely consistent-shooting ammo with your Gold Medal Match sizing dies. Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".

Similar listings