GEISSELE AR15/M4 Gas Block Roll Pin Punch Set

42.90 €

No permit required (18+)

8700 Leoben, Austria

ID: 10090123

Shop safely with Gunfinder

Our AI-powered seller identity verification makes Gunfinder the safest marketplace online. Learn more

About the seller

Earms

Dealer

3,748 listings

Details

Original language

German

Category

Condition

New

Location

🇦🇹 8700 Leoben, Austria

Availability

Unknown delivery time

Freshness

This listing is based on a mirrored offer, where the listing data was synced to us from a shop, dealer, or external marketplace. Please note that temporary price discrepancies may occur due to possible delays in data transmission.

Source: Earms
Last updated: about 15 hours ago

Description

Note: The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.

The Geissele Gas Block Roll Pin Punch Set is made specifically for the removal and installation of the 0.078" roll pin that secures the gas tube to the gas block of an AR-15/AR-10. Removal of a rusted-in gas block roll pin has always been a challenge since there are no commercial pin punches in 0.078" diameter. Additionally, 1/16" (0.062") punches have a tendency to bend and very few starter punches are available in 1/16" diameter. The Geissele Gas Block Pin Punch Set makes gas block work a whole lot easier. The first punch to grab when removing the roll pin is the Starter Punch. This is the punch with the long, tapered end. The long taper is much more resistant to bending and buckling than the straight shank of the Pin Punch. Use the Starter Punch (Not included) to get the roll pin moving. Then, use the Pin Punch to drive the roll pin out completely. The Geissele Gas Block Pin Punch Set is made from properly hardened and tempered 01 tool steel. The Gas Block Pin Punch Set is considered a consumable item, meaning they will eventually wear out and will need to be replaced. Geissele will not replace tools damaged from misuse or normal wear and tear. Always make sure your weapon is unloaded and the magazine removed before starting work. Spec: This tool is designed to punch a 0.078” diameter roll pin in or out from a gas block Compatibility: Compatible with AR-15/AR-10 0.078” diameter gas block roll pins Note: Use the Gas Block Roll Pin Starter Tool to get the roll pin moving (SKU: 10-225) MADE IN THE USA

GEISSELE AR15/M4 Gas Block Roll Pin Punch Set

Earms

Details

Freshness

Description

You might also like

Sell on Gunfinder for free

Top Auctions

Buying Service

Sponsored listings