Note:
The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.
IGB conversion barrel GLOCK Gen3&4 original dimensions barrel length up to 7.5' possible, please specify when ordering Thread and porting completely tested according to German law For a properly functioning casing ejection when using the 9mm barrel, we strongly recommend replacing the original .40 or .357 control block with the 9mm block. This 9mm control block usually also works perfectly for the original calibers .40&SW as well as .357SIG and does not need to be replaced every time. available GLOCK control blocks Due to manufacturing tolerances of barrel and slide, minor fitting work may be required, which should be carried out by a competent professional.
(Show description in original language)
IGB Wechsellauf GLOCK Gen5 original Abmessungen Lauflänge bis 7,5' möglich, bitte bei Bestellung angeben Gewinde und Portungen gegen Aufpreis komplett beschossen nach Deutschem RechtFür einen einwandfrei funktionierenden Hülsen-Auswurf bei Verwendung des 9mmLaufs, empfehlen wir dringend den Austausch des original .40er oder .357er Steuerblock gegen den 9mm Block.Dieser 9mm SteuerBlock funktioniert normalerweise auch einwandfrei für die UrsprungsKaliber .40&SW wie auch .357SIG und muß somit nicht jedes Mal getauscht werden.erhältliche GLOCK SteuerBlöcke Auf Grund von Fertigungstoleranzen von Lauf und Verschluß kann es zu geringfügigen Anpaßarbeiten kommen, die von einem kompetenten Fachmann durchgeführt werden sollten. WGR = KWL