CLAWGEAR AR15 TWO CHAMBER COMPENSATOR 1/2 X 28 UNEF CAL 223
84.90 €
No permit required (18+)
4240 Freistadt, Austria
0
ID: 10088167
Shop safely with Gunfinder
Our AI-powered seller identity verification makes Gunfinder the safest marketplace online.
Learn more
Details
- Original language
- German
- Category
- Condition
- New
- Location
- 🇦🇹 4240 Freistadt, Austria
- Availability
- Limited availability
Freshness
This listing is based on a mirrored offer, where the listing data was synced to us from a shop, dealer, or external marketplace. Please note that temporary price discrepancies may occur due to possible delays in data transmission.
- Source
- Shootingstore
- Last updated
- about 5 hours ago
Description
Note:
The item is located abroad. Please note that delivery conditions, shipping times, and/or the purchase process may differ.
Claw Gear‘s modular firearms accessories products are designed to increase weapon performance and accuracy. Due to it‘s outstanding materials construction, this rugged and high quality made item will serve you in any situation.
B&T Quick Detach
Allows the operator to enhance the weapon system with B&T QD (Rotex-V) suppressors.
Expansion Chamber
The construction guides the exhaust gases in optimal direction to reduce recoil and muzzle flip.
Crush Washer
Mount the AR-15 TWO CHAMBER Compensator with the crush washer to ensure the correct alignment on the barrel.
Closed Bottom
Prevents blown up dust and debris.
Closed Top
Prevents distraction in the line of sight.
Compatibility: All AR-15 and M16 variants in .223 or 5.56 mm caliber with a barrel thread of 1/2 x 28
TPI UNEF, for example: Hera Arms The 15th, Schmeisser AR15, DPMS AR-15, etc... Does not fit Oberland Arms OA-15
Installation: Make sure your weapon is unloaded and safe. Dismount existing muzzle devices and clean the thread surface. After applying a drop of oil on the thread, put the crush washer over the thread (the conical end facing towards muzzle). Screw the compensator clockwise on the barrel by hand until it's snugly. Then use a 19 mm wrench to tighten the compensator until the Clawgear logo faces upwards.
