Kit di punte per trapano Magic Bore
≈ 80 €
Prezzo dal rivenditore: 599 kr. Convertito al tasso BCE del 30 ottobre 2026.
Di libera vendita
1260 København K, Danimarca
0
ID: 11358722
Acquisto da fuori UE: l'arma passa tramite un importatore nel tuo paese, il rivenditore si occupa dell'esportazione.
Come funziona l’acquisto dall’Europa
Acquista in sicurezza con Gunfinder
La nostra verifica d'identità con IA sui venditori rende Gunfinder il marketplace più sicuro online.
Scopri di più
Dettagli
- Lingua originale
- Inglese
- Categoria
- Condizione
- Nuovo
- Posizione
- 1260 København K, Danimarca
- Disponibilità
- disponibile
Aggiornamento
Questa offerta si basa su una sincronizzazione dei dati, in cui le informazioni sull'offerta sono state trasmesse da un negozio, rivenditore o marketplace esterno. Tieni presente che potrebbero verificarsi temporanee discrepanze di prezzo a causa di possibili ritardi nella trasmissione dei dati.
- Fonte
- Gameandgun
- Ultimo aggiornamento
- circa 11 ore fa
Descrizione
Nota:
L'articolo si trova all'estero. Tieni presente che le condizioni di consegna, i tempi di spedizione e/o la procedura di acquisto potrebbero variare.
The Drill Kit is designed to clean ONLY the first 2/3 of the barrels - down to the end of the forcing cones - and it is designed to remove any stubborn lead or plastic fouling that may have built up or for that first clean after using competitor products as your gun will NOT be clean. It is NOT meant to be used from the choke end or you will distort the brush and reduces it's effectiveness from the end that it is designed to clean. You will also need to use the Hand Kit to push the powder out from the remaining 1/3 of the barrels after using the Drill Kit.
The Drill Kit comprises of a hexagon metal rod designed to fit into a 13mm drill chuck and prevent slipping. It has a protective plastic bush on the end to protect the gun from the drill which also fits snugly into the plastic tube with an end cap which again is designed to keep all dirty components contained. There is one material covered rod and a heavy duty custom brush with a protective plastic tip designed solely for use in a drill in forward motion and at slow speed. The Drill Kit works best without any oils or solvents. It will remove fouling faster and turns it to a powder. If you do use oils , solvents or lubricants it will turn it to a sludge which will coat the material covered rods and shorten the life of the consumables.
IMPORTANT: Please hold the barrels with a towel or rag wrapped around them as the new drill kit brush heats the barrels up quickly and they may become too hot to hold if you don't. Take the drill kit and whilst still in the tube attach your drill. Set it to operate in forward motion and at its slowest speed. Slowly start the drill and pull the drill backward whilst holding the tube to remove it. Position the brush just inside the first barrel and start the drill. Slowly push the brush down the barrel and then withdraw it again slowly. Check the chamber by pointing it up towards a gentle light source i.e. not the sun and check that the plastic fouling has been removed. If not repeat this process. Repeat for the other barrel. Replace the plastic tube and undo the drill chuck and you are done.
