STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU, immagine 1 di 3

STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU

39,90 €

Di libera vendita

8700 Leoben, Austria

ID: 10089587

Acquista in sicurezza con Gunfinder

La nostra verifica d'identità con IA sui venditori rende Gunfinder il marketplace più sicuro online. Scopri di più

Il venditore

Earms

Rivenditore

3.748 annunci

Dettagli

Lingua originale

Tedesco

Categoria

Condizione

Nuovo

Posizione

🇦🇹 8700 Leoben, Austria

Disponibilità

tempi di consegna sconosciuti

Aggiornamento

Questa offerta si basa su una sincronizzazione dei dati, in cui le informazioni sull'offerta sono state trasmesse da un negozio, rivenditore o marketplace esterno. Tieni presente che potrebbero verificarsi temporanee discrepanze di prezzo a causa di possibili ritardi nella trasmissione dei dati.

Fonte: Earms
Ultimo aggiornamento: circa 11 ore fa

Descrizione

Nota: L'articolo si trova all'estero. Tieni presente che le condizioni di consegna, i tempi di spedizione e/o la procedura di acquisto potrebbero variare.

The Strike Industries AR Mil-Spec Buffer Housing gives the user a cost-effective means of customization while retaining functionality. The AR-15 buffer is often an overlooked part of the gas system that is needed to properly fine-tune your specific setup. This buffer housing is machined from 6061-T6 aluminum and designed to fit Mil-Spec standard or carbine length receiver extensions/buffer tubes while also providing a level of customization. The SI AR Mil-Spec Buffer Housing is shipped without weights so that you can either replace your current housing, use existing weights or opt to purchase weights to refine the weapons gas system to your specific needs. The NBR rubber material buffer pad helps absorb impact and is secured by the included roll pin. By modulating the weight through the combination of tungsten, steel and aluminum weights, the user is given a cost-effective means of adjusting the weapons reciprocating mass, and thus the recoil experienced by the shooter with the Strike Industries AR Mil-Spec Buffer Housing. COMPATIBILITY:-14mm (0.55") diameter Mil-Spec buffer weights and spacers (maximum of 14.20mm)-Mil-Spec standard and carbine length receiver extensions/buffers NOTE:-Buffer housing only, no weights or spacers included-Due to numerous factors that take place during the anodization process, the color lines from batch to batch of a certain product may vary -LENGTH: 83.15 (with buffer pad)-WIDTH: 25.25mm (curve to curve)-HEIGHT: 24mm (flat to curved)-WEIGHT: 1.0 oz-WEIGHT W/ PKG: 1.2 ozMONTAGEVIDEOMADE IN THE USA

Stampa