Race Master Insert

59 €

Vrij te koop (vanaf 18 jaar)

6010 Innsbruck, Oostenrijk

ID: 10082174

Veilig kopen met Gunfinder

Onze AI-gestuurde identiteitsverificatie van verkopers maakt Gunfinder tot de veiligste marktplaats online. Meer weten

Over de verkoper

Sportwaffen Selector

Dealer

4.836 advertenties

Details

Originele taal

Duits

Categorie

Staat

Nieuw

Locatie

🇦🇹 6010 Innsbruck, Oostenrijk

Beschikbaarheid

leverbaar

Actualiteit

Dit aanbod is gebaseerd op een aanbiedingssynchronisatie, waarbij de aanbiedingsgegevens vanuit een shop, handelaar of extern platform naar ons zijn overgedragen. Houd er rekening mee dat door mogelijke vertragingen bij de gegevensoverdracht tijdelijke prijsafwijkingen kunnen optreden.

Bron: Sportwaffen Selector
Laatst bijgewerkt: ongeveer 17 uur geleden

Beschrijving

Opmerking: Het artikel bevindt zich in het buitenland. Houd er rekening mee dat hierdoor de leveringsvoorwaarden, verzendtijden en/of het aankoopproces kunnen verschillen.

Note: Both the Race Master and the Alpha-X holsters use the same insert blocks. The Race Master Holster utilizes an efficient and easy system to allow shooters to switch their holster from one gun type to another by means of changing the Insert Block Assembly. This switch is fast and easy and can be done in less than a minute, and without losing any of the holster's adjustments or settings. The Insert Block Assembly includes:1. The Locking Block (gun specific).2. The Sliding Lock, assembled (gun specific).3. The safety lever, assembled.4. The internal magnetic activation system, assembled.5. “Magnetic logo” to cover over side hole in holsters which may still have it. The Insert block grips the pistol only on the front end of the trigger guard, and a very precise fit is required in that area. In some cases some light modifications to the Insert Block may be required. Should you need to dismantle your insert block for some fitting, follow these steps:1. Remove the insert block from the holster by removing the two small M4 screws from the back of the holster.2. Using a punch and hammer, push the two steel pins from the front of the block towards the back (push from the side with the gun type engraved). These pins may be tight.3. Once the pins are out, the plastic wedge holding the 2nd magnet will come out. Make sure the magnet does not fall out the part. It is usually held snugly it its pocket.4. Use a marker to make a dot on the top of the magnet which is embedded in the slide lock. This will make it easy for you to ensure that you reassemble it with the correct side up. Most likely it will fall out or you will want to remove it while fitting the slide lock.5. To remove the slide lock from the block, unscrew the M3 screw visible from the back of the block – and then slide the slide lock upwards and out through the window in the block – passed the safety lever, which must be in the unlocked position. To reassemble- reverse your steps. The Race-Master Holster Insert Blocks are design to be used in either RH or LH holsters. The same insert works for both.

Afdrukken

Race Master Insert

Sportwaffen Selector

Details

Actualiteit

Beschrijving

Dit vind je misschien ook interessant

Inkoopservice

Topveilingen

Gratis verkopen op Gunfinder

Gesponsorde aanbiedingen