Achtung: Ton navigateur est obsolète. Attention, Gunfinder risque donc de ne pas fonctionner partout. Mets-le à jour dès que possible. En savoir plus !
Gunfinder is also available in other languages.

RADIAN WEAPONS GLOCK® 19 / 19X / 45 / 47 / 49 GEN1-5 COMPRESSOR™ Quick-Tune Guide Rod Kit

135,90 €
8700 Leoben, Autriche
0
ID: 10094086
Cette offre n'est actuellement pas disponible.
Achète en toute sécurité avec Gunfinder
Notre vérification d'identité basée sur l'IA fait de Gunfinder la place de marché la plus sûre en ligne. En savoir plus
À propos du vendeur
Earms
Marchand

Détails

Langue originale
Allemand
Marque
Glock
Produit
Glock 19
Catégorie
Autorisation d'achat
Requis - Qu'ai-je le droit d'acheter ?
État
Neuf
Localisation
🇦🇹 8700 Leoben, Autriche
Disponibilité
indisponible

Actualité

Cette offre est basée sur une synchronisation d'annonce, par laquelle les données de l'offre ont été transmises depuis une boutique, un marchand ou une place de marché externe. Merci de noter que des écarts de prix temporaires peuvent survenir en raison de délais éventuels lors de la transmission des données.
Source
Earms
Dernière mise à jour
il y a environ 15 heures

Description

Remarque : L'article est situé à l'étranger. Note que les conditions de livraison, les délais d'expédition et/ou la procédure d'achat peuvent varier.
Most adjustable guide rods on the market use a cap screw to retain the spring. The problem? Loose screws are too common and thread locker forces you to commit to one spring weight.Enter the screwless design of the COMPRESSOR Quick-Tune Guide Rod. The dovetail interface is captured by the spring, creating a simple and secure lock-up. Flutes along the guide rod allow the spring to move with less friction for smoother cycling. The heat treated guide rod has a slick, durable, and corrosion-resistant Nitride finish. Included: 1 - Hardened 17-4 SS Guide Rod 3 - Flat wire Springs in 13lb, 15lb, and 18 lb weights 1 - SS Washer for Gen3 1 – SS Captive bushing for Gen4 & Gen5 compatibility Specs: Compatible with GLOCK® 19 / 19X / 45 / 47 / 49 GEN1-5 models NOT compatible with other models INSTALLATION INSTRUCTIONS STEP 1 | Compress installed spring and insert tool* into the cross hole to hold the spring down. STEP 2 | Remove the dovetailed end cap. Then remove the tool from the cross hole, allowing the spring to be removed. STEP 3 | Install a different spring weight, compress new spring, and insert the tool back into the cross hole again. STEP 4 | Align dovetail to install cap, remove the tool, and allow spring to capture around the dovetail interface. While a tool is not necessary for the Radian guide rod, it can assist in holding the spring down when removing and installing the cap. MADE IN THE USA

Ça pourrait aussi t'intéresser

Meilleures enchères

Offres sponsorisées