Achtung: Ton navigateur est obsolète. Attention, Gunfinder risque donc de ne pas fonctionner partout. Mets-le à jour dès que possible. En savoir plus !

Zero Locking Die Ring 7/8" lot multiple (4 bagues)

≈ 127 €
Prix chez le marchand: 1 395 kr. Converti au taux de la BCE du 3 novembre 2026.
Catégorie d'arme D
532 40 SKARA, Suède
0
ID: 11613610
Achat hors UE : l’arme passe par un importateur dans ton pays, le marchand s’occupe de l’exportation. Voici comment se déroule l’achat depuis l’Europe
Achète en toute sécurité avec Gunfinder
Notre vérification d'identité basée sur l'IA fait de Gunfinder la place de marché la plus sûre en ligne. En savoir plus
À propos du vendeur
Astro Sweden
Marchand

Détails

Langue originale
Suédois
Catégorie
État
Neuf
Localisation
532 40 SKARA, Suède
Disponibilité
disponible

Actualité

Cette offre est basée sur une synchronisation d'annonce, par laquelle les données de l'offre ont été transmises depuis une boutique, un marchand ou une place de marché externe. Merci de noter que des écarts de prix temporaires peuvent survenir en raison de délais éventuels lors de la transmission des données.
Source
Astro Sweden
Dernière mise à jour
il y a environ 15 heures

Description

Remarque : L'article est situé à l'étranger. Note que les conditions de livraison, les délais d'expédition et/ou la procédure d'achat peuvent varier.
Through the research and development process for the ZERO, it became a testing bed for MANY reloading products. We needed to isolate variables, and ensure we were testing the press and not just the dies/shellholders/etc. One of the major culprits we found for inconsistency was actually lock rings. MOST lock rings on the market are held into place by a set screw or they’re split/clamp style. We found these to be inconsistent by design, as they needed to secure themselves to the dies for constant removal/replacement in single-stage presses.
So, we decided to make our own. Here’s where we landed:
LARGE DIAMETER – more surface contact with the turret head means the ring will align with the press and force the die straight, instead of grabbing onto the die and aligning as it may.
MORE THREAD ENGAGEMENT – the rings feature .350? of thread engagement, which is 15-25% more than common die lock rings. This results in roughly a full thread of additional engagement, increasing the ability of the ring to square the die to the press.
INTERNAL WRENCH ENGAGEMENT – with traditional rings, there is a flat or knurling on the outside, which requires you to get a wrench around the outside to tighten. On a multi-die head this requires you to get tools between dies and fight with the location – or you have to make the ring smaller which has real downsides. This ring is designed with internal wrench engagement, mitigating this issue altogether.
PRECISION STAINLESS STEEL MANUFACTURING – The threads and bottom face of the ring are machined in a single operation, delivering square surfaces to align your die. We then leave the ring and threads hole and unobscured by splits and grub screws. All rings are made of 17-4PH stainless steel. Available in raw stainless or with a black nitride finish.
Total thickness of rings is .500? and outside diameter is 1.685?

Artikelattribut
Exkludera från marknadsföring Ja Varumärke Area 419 Lagerprofil 4

Offres similaires