Achtung: Ton navigateur est obsolète. Attention, Gunfinder risque donc de ne pas fonctionner partout. Mets-le à jour dès que possible. En savoir plus !
Gunfinder is also available in other languages.

Geissele 9mm outil d'alignement de suppresseur

≈ 113 €
Prix chez le marchand: 105 CHF. Converti au taux de la BCE du 13 octobre 2026.
Catégorie d'arme D
1257 La Croix-de-Rozon, Suisse
0
ID: 10506318
Achat hors UE : l’arme passe par un importateur dans ton pays, le marchand s’occupe de l’exportation. Voici comment se déroule l’achat depuis l’Europe
Achète en toute sécurité avec Gunfinder
Notre vérification d'identité basée sur l'IA fait de Gunfinder la place de marché la plus sûre en ligne. En savoir plus
À propos du vendeur
Dynamikarms
Marchand

Détails

Langue originale
Allemand
Catégorie
État
Neuf
Localisation
🇨🇭 1257 La Croix-de-Rozon, Suisse
Disponibilité
disponible

Actualité

Cette offre est basée sur une synchronisation d'annonce, par laquelle les données de l'offre ont été transmises depuis une boutique, un marchand ou une place de marché externe. Merci de noter que des écarts de prix temporaires peuvent survenir en raison de délais éventuels lors de la transmission des données.
Source
Dynamikarms
Dernière mise à jour
il y a environ 13 heures

Description

Remarque : L'article est situé à l'étranger. Note que les conditions de livraison, les délais d'expédition et/ou la procédure d'achat peuvent varier.
9mm Suppressor Alignment GageThe Geissele Suppressor Alignment Gage (SAG) is a precision gage used to verify the alignment of a suppressor to the bore of a firearm barrel. It is important to understand that the length of the suppressor is usually much longer than the length of the barrel / muzzle device / suppressor interface geometry. A small deviation at the mounting interface means a much larger deviation of the suppressor exit hole. The deviations from nominal can also be additive which compounds suppressor misalignment. The Geissele SAG is manufactured from hardened steel that has been ground 0.002” under nominal bore diameter. The outside diameter of the SAG is finely finished and straight to 0.001” over its length. Geissele hardens the SAG so that it will not wear by sliding exposure to abrasive powder residue, pull burrs if it slides against misaligned baffles nor allow abrasive particle to imbed into the surface of the gage. There can be a wide variation in barrel bore diameters and bore straightness. 0.002” under nominal bore diameter has been found to be the best size of the SAG that will fit most barrels. The long length of the SAG aligns the gage to the bore; it is not necessary to have a very tight fitting gage with the long length of the Geissele SAG.Caliber: 9mm16" LengthManufactured from hardened steel that has been ground 0.002” under nominal bore diameterOutside diameter is finely finished and straight to 0.001” over its lengthMade in the U.S.A.

Ça pourrait aussi t'intéresser

Meilleures enchères

Offres sponsorisées