Achtung: Ton navigateur est obsolète. Attention, Gunfinder risque donc de ne pas fonctionner partout. Mets-le à jour dès que possible. En savoir plus !
Gunfinder is also available in other languages.

GEISSELE AR15/M4 Gas Block Roll Pin Punch Set

42,90 €
8700 Leoben, Autriche
0
ID: 10090123
Achète en toute sécurité avec Gunfinder
Notre vérification d'identité basée sur l'IA fait de Gunfinder la place de marché la plus sûre en ligne. En savoir plus
À propos du vendeur
Earms
Marchand

Détails

Langue originale
Allemand
Catégorie
État
Neuf
Localisation
🇦🇹 8700 Leoben, Autriche
Disponibilité
délai de livraison inconnu

Actualité

Cette offre est basée sur une synchronisation d'annonce, par laquelle les données de l'offre ont été transmises depuis une boutique, un marchand ou une place de marché externe. Merci de noter que des écarts de prix temporaires peuvent survenir en raison de délais éventuels lors de la transmission des données.
Source
Earms
Dernière mise à jour
il y a environ 15 heures

Description

Remarque : L'article est situé à l'étranger. Note que les conditions de livraison, les délais d'expédition et/ou la procédure d'achat peuvent varier.
The Geissele Gas Block Roll Pin Punch Set is made specifically for the removal and installation of the 0.078" roll pin that secures the gas tube to the gas block of an AR-15/AR-10. Removal of a rusted-in gas block roll pin has always been a challenge since there are no commercial pin punches in 0.078" diameter. Additionally, 1/16" (0.062") punches have a tendency to bend and very few starter punches are available in 1/16" diameter. The Geissele Gas Block Pin Punch Set makes gas block work a whole lot easier. The first punch to grab when removing the roll pin is the Starter Punch. This is the punch with the long, tapered end. The long taper is much more resistant to bending and buckling than the straight shank of the Pin Punch. Use the Starter Punch (Not included) to get the roll pin moving. Then, use the Pin Punch to drive the roll pin out completely. The Geissele Gas Block Pin Punch Set is made from properly hardened and tempered 01 tool steel. The Gas Block Pin Punch Set is considered a consumable item, meaning they will eventually wear out and will need to be replaced. Geissele will not replace tools damaged from misuse or normal wear and tear. Always make sure your weapon is unloaded and the magazine removed before starting work. Spec: This tool is designed to punch a 0.078” diameter roll pin in or out from a gas block Compatibility: Compatible with AR-15/AR-10 0.078” diameter gas block roll pins Note: Use the Gas Block Roll Pin Starter Tool to get the roll pin moving (SKU: 10-225) MADE IN THE USA

Ça pourrait aussi t'intéresser

Meilleures enchères

Offres sponsorisées