Achtung: Ton navigateur est obsolète. Attention, Gunfinder risque donc de ne pas fonctionner partout. Mets-le à jour dès que possible. En savoir plus !
Gunfinder is also available in other languages.

STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU

39,90 €
8700 Leoben, Autriche
0
ID: 10089587
Achète en toute sécurité avec Gunfinder
Notre vérification d'identité basée sur l'IA fait de Gunfinder la place de marché la plus sûre en ligne. En savoir plus
À propos du vendeur
Earms
Marchand

Détails

Langue originale
Allemand
Catégorie
État
Neuf
Localisation
🇦🇹 8700 Leoben, Autriche
Disponibilité
délai de livraison inconnu

Actualité

Cette offre est basée sur une synchronisation d'annonce, par laquelle les données de l'offre ont été transmises depuis une boutique, un marchand ou une place de marché externe. Merci de noter que des écarts de prix temporaires peuvent survenir en raison de délais éventuels lors de la transmission des données.
Source
Earms
Dernière mise à jour
il y a environ 11 heures

Description

Remarque : L'article est situé à l'étranger. Note que les conditions de livraison, les délais d'expédition et/ou la procédure d'achat peuvent varier.
The Strike Industries AR Mil-Spec Buffer Housing gives the user a cost-effective means of customization while retaining functionality. The AR-15 buffer is often an overlooked part of the gas system that is needed to properly fine-tune your specific setup. This buffer housing is machined from 6061-T6 aluminum and designed to fit Mil-Spec standard or carbine length receiver extensions/buffer tubes while also providing a level of customization. The SI AR Mil-Spec Buffer Housing is shipped without weights so that you can either replace your current housing, use existing weights or opt to purchase weights to refine the weapons gas system to your specific needs. The NBR rubber material buffer pad helps absorb impact and is secured by the included roll pin. By modulating the weight through the combination of tungsten, steel and aluminum weights, the user is given a cost-effective means of adjusting the weapons reciprocating mass, and thus the recoil experienced by the shooter with the Strike Industries AR Mil-Spec Buffer Housing. COMPATIBILITY:-14mm (0.55") diameter Mil-Spec buffer weights and spacers (maximum of 14.20mm)-Mil-Spec standard and carbine length receiver extensions/buffers NOTE:-Buffer housing only, no weights or spacers included-Due to numerous factors that take place during the anodization process, the color lines from batch to batch of a certain product may vary -LENGTH: 83.15 (with buffer pad)-WIDTH: 25.25mm (curve to curve)-HEIGHT: 24mm (flat to curved)-WEIGHT: 1.0 oz-WEIGHT W/ PKG: 1.2 ozMONTAGEVIDEOMADE IN THE USA

Ça pourrait aussi t'intéresser

Meilleures enchères

Offres sponsorisées