Achtung: Ton navigateur est obsolète. Attention, Gunfinder risque donc de ne pas fonctionner partout. Mets-le à jour dès que possible. En savoir plus !
Gunfinder is also available in other languages.

FAXON Streamline GEN3 AR-15 M-LOK Handguard 9"

219,90 €
8700 Leoben, Autriche
0
ID: 10083212
Achète en toute sécurité avec Gunfinder
Notre vérification d'identité basée sur l'IA fait de Gunfinder la place de marché la plus sûre en ligne. En savoir plus
À propos du vendeur
Earms
Marchand

Détails

Langue originale
Allemand
Catégorie
État
Neuf
Localisation
🇦🇹 8700 Leoben, Autriche
Disponibilité
délai de livraison inconnu

Actualité

Cette offre est basée sur une synchronisation d'annonce, par laquelle les données de l'offre ont été transmises depuis une boutique, un marchand ou une place de marché externe. Merci de noter que des écarts de prix temporaires peuvent survenir en raison de délais éventuels lors de la transmission des données.
Source
Earms
Dernière mise à jour
il y a environ 13 heures

Description

Remarque : L'article est situé à l'étranger. Note que les conditions de livraison, les délais d'expédition et/ou la procédure d'achat peuvent varier.
Easy installation, no special tools are required to assemble the barrel nut! Faxon is proud to offer the Gen 3 Streamline Series of handguards to compliment any Modern Sporting Rifle. The handguard is 100% made in the USA from extruded 6061 aluminum. The handguards are hard-coat anodized black and feature a steel barrel nut. Mounting is extremely simple with common tools and the handguard features alignment tabs to ensure it cannot rotate during vigorous movement. Specifications: Height (Flat to Flat): 1.54"Max Outer Diameter (Peak to Peak): 1.67"Max Inner Diameter: 1.34"Weight: 0.67 lbsConstruction: 6061 Aluminum - Hard Coat AnodizedAccessory Mounting: M-LOK Installation Instructions: Torque barrel nut to industry specs using 1-3/16” wrench to at least 35ft/lbs but no more than 60ft/lbs. DO NOT OVER-TIGHTEN.Install handguard over the barrel nut aligning the upper receiver rail between the alignment tabs.Install locking plate into the recess on the handguard and thread both bolts through the handguard and into the locking plate. Torque bolts to 32 in/lbs.After the initial live fire test, check to make sure the bolts are still tight and not walking out.

Ça pourrait aussi t'intéresser

Meilleures enchères

Offres sponsorisées