DAA – Alpha-X-pose-farveindlæg
≈ 33 kr
Pris hos forhandleren: 49 kr. Omregnet efter ECB-kursen fra 13. november 2026.
Ingen tilladelse påkrævet
254 64 Helsingborg, Sverige
0
ID: 11602124
Køb fra et land uden for EU: Våbnet går gennem en importør i dit land, og forhandleren sørger for eksporten.
Sådan foregår køb fra Europa
Køb sikkert med Gunfinder
Vores AI-baserede identitetskontrol af sælgerne gør Gunfinder til den sikreste markedsplads på nettet.
Læs mere
Detaljer
- Originalsprog
- Svensk
- Kategori
- Stand
- Ny
- Placering
- 🇸🇪 254 64 Helsingborg, Sverige
- Tilgængelighed
- kan leveres
Aktualitet
Dette tilbud er en kopi, hvor tilbudsdata er blevet overført til os fra en webshop, forhandler eller ekstern markedsplads. Bemærk, at eventuelle forsinkelser i dataoverførslen kan medføre midlertidige prisforskelle.
- Kilde
- RangeMaster Store
- Sidst tjekket hos forhandleren
- for cirka 7 timer siden
Beskrivelse
Bemærk:
Varen befinder sig i udlandet. Bemærk, at leveringsbetingelser, leveringstider og/eller købsproceduren derfor kan være anderledes.
Includes left, right and side inlays. Depending on where you mount the ball joint attachment, one inlay part will not be used.
Please note that these inlays have a protective transparent film on their front and 3m adhesive tape cover on their back. both should be peeled off before installation..
In order to install the inlays do the following:
Carefully break the pieces out of their frame. There are several small bridges holding them in place which can be broken by hand.
If you wish, you can use a knife to clean off the tails left by the bridges, but this should not be strictly necessary.
Peel off the transparent film from the front, as well as the 3M adhesive cover from the back.
Position the inlays over their correct pockets in the pouch body and fit them in place.
Should you wish you remove the inlays after installation, you can do so thanks to the small holes drilled through the pouch body. In order to access these holes, you will need to remove all plastic spacers first. Then, using a sharp tool (like a small hex key) you can push on the inside of the inlay until it comes loose in the corner. Then, gently work it out of its pocket. Note that the inlay may break when removed.
