Achtung: Din browser er forældet. Bemærk, at dele af Gunfinder derfor ikke vil fungere. Du bør opdatere din browser så snart som muligt. Læs mere her!

MDT – LRA S90-beslag til Send iT MV3 og Spuhr-monteringer

≈ 619 kr
Pris hos forhandleren: 82,83 €. Omregnet efter ECB-kursen fra 17. november 2026.
Ingen tilladelse påkrævet
25710 Vreta, Finland
0
ID: 11470353
Køb fra et land uden for EU: Våbnet går gennem en importør i dit land, og forhandleren sørger for eksporten. Sådan foregår køb fra Europa
Køb sikkert med Gunfinder
Vores AI-baserede identitetskontrol af sælgerne gør Gunfinder til den sikreste markedsplads på nettet. Læs mere
Om sælgeren
MILDOT Finland
Forhandler

Detaljer

Originalsprog
Engelsk
Kategori
Stand
Ny
Placering
🇫🇮 25710 Vreta, Finland
Tilgængelighed
kan leveres

Aktualitet

Dette tilbud er en kopi, hvor tilbudsdata er blevet overført til os fra en webshop, forhandler eller ekstern markedsplads. Bemærk, at eventuelle forsinkelser i dataoverførslen kan medføre midlertidige prisforskelle.
Kilde
MILDOT Finland
Sidst tjekket hos forhandleren
for cirka 3 timer siden

Beskrivelse

Bemærk: Varen befinder sig i udlandet. Bemærk, at leveringsbetingelser, leveringstider og/eller købsproceduren derfor kan være anderledes.
MOUNT YOUR LEVEL & TIMER TO SPUHR SCOPE MOUNTS

Vertically mount directly to Spuhr’s SP, SA, SS, and ST models.

INCLUDED<

– MV3 S90 bracket

– 8-32 x3.8FH Screw x1

– M4x0.7-10mm FH screw x2

Some mounts may require Spuhr A-0001: Spacer 4mm. Contact your Spuhr dealer for specific applications.

**Warning** Screw lengths MUST be checked PRIOR to attaching the mounts. In some applications the screw can “bottom out” against the scope tube or damage other components if the screw length is excessive or the wrong size/thread pitch is used. YOU are RESPONSIBLE to check the length and size of screws and verify interferences before final assembly. LRA is not liable for damage to our products or the products they are being mounted or attached to.

Step 1- Attach the LRA S90 to the Spuhr mount using the (2) supplied 4mm x 10mm flat head screws using either an IP20 or T20 Torx Plus or Torx drive. Torque both screws to 20-25 in-lbs.

Step 2- attach the Send iT MV3 to the LRA S90 bracket. Follow the instructions included with the Send iT MV3 for removal of the Picatinny mount (link below). Carefully fit the Send iT into the pocket of the LRA S90 bracket by hand and confirm it’s sitting flat and fully seated BEFORE installing the screw. Install and torque the (1) supplied # 8-32 Flat head screw to 30-34 in-lbs using a 3/32 Allen drive.

SKU:107203-BLK

Lignende tilbud