Rørmagasinfjeder – FACTORY Innovatac COMPS teleskopisk magasinfjeder
≈ 187 kr
Pris hos forhandleren: 25 €. Omregnet efter ECB-kursen fra 11. november 2026.
Ingen tilladelse påkrævet
42100 Jämsä, Finland
0
ID: 11409137
Køb fra et land uden for EU: Våbnet går gennem en importør i dit land, og forhandleren sørger for eksporten.
Sådan foregår køb fra Europa
Køb sikkert med Gunfinder
Vores AI-baserede identitetskontrol af sælgerne gør Gunfinder til den sikreste markedsplads på nettet.
Læs mere
Detaljer
- Originalsprog
- Finsk
- Kategori
- Stand
- Ny
- Placering
- 🇫🇮 42100 Jämsä, Finland
- Tilgængelighed
- kan leveres
Aktualitet
Dette tilbud er en kopi, hvor tilbudsdata er blevet overført til os fra en webshop, forhandler eller ekstern markedsplads. Bemærk, at eventuelle forsinkelser i dataoverførslen kan medføre midlertidige prisforskelle.
- Kilde
- Aawee
- Sidst tjekket hos forhandleren
- for cirka 7 timer siden
Beskrivelse
Bemærk:
Varen befinder sig i udlandet. Bemærk, at leveringsbetingelser, leveringstider og/eller købsproceduren derfor kan være anderledes.
Description:
COMPS is a magazine spring family engineered for competition shotguns.
COMPS telescopic magazine spring is designed to fit most available telescopic tubes. The geometry of the spring will reduce tube sticking and maximize the telescopic capacity.
Depending on the original setup, total capacity increase up to 5% can be achieved with optimal COMPS spring combination.
What this means is that you could be able to fit that one extra shell without sacrificing reliability. Or use longer springs for added reliability for your magazine system.
This spring will allow you to tune your telescopic system for function and capacity. And also be a high quality general spare spring for all systems.
Recommendation is to use a spring setup, that will start the telescopic expansion when the inner tube is 100% full (typically 10 shells).
Using this recommendation will keep the telescopic system from expanding unnecessarily, keep it short and keep it clean as possible.
Minimum recommended setup is when telescopic expansion starts at 90% full (typically 9 shells).
Note: the spring is most likely tighter fit during assembly than the orginal spring. This is OK, and it is designed that way.
The diameter and clearance of the spring increases when compressed.
Specifications:
Length 760mm
High quality steel spring wire
Fits all known telescopic tubes (inner tube diameter up to 26mm)
