DAA XL650 tændhætteudgangsrørsamling

≈ 171 kr

Pris hos forhandleren: 21 CHF. Omregnet efter ECB-kursen fra 30. oktober 2026.

Ingen tilladelse påkrævet

5036 Oberentfelden, Schweiz

ID: 10552094

Køb fra et land uden for EU: Våbnet går gennem en importør i dit land, og forhandleren sørger for eksporten. Sådan foregår køb fra Europa

Køb sikkert med Gunfinder

Vores AI-baserede identitetskontrol af sælgerne gør Gunfinder til den sikreste markedsplads på nettet. Læs mere

Om sælgeren

Shooting Store

Forhandler

10.438 tilbud

Detaljer

Originalsprog

Tysk

Kategori

Stand

Placering

🇨🇭 5036 Oberentfelden, Schweiz

Tilgængelighed

kan forudbestilles

Aktualitet

Dette tilbud er en kopi, hvor tilbudsdata er blevet overført til os fra en webshop, forhandler eller ekstern markedsplads. Bemærk, at eventuelle forsinkelser i dataoverførslen kan medføre midlertidige prisforskelle.

Kilde: Shooting Store
Senest opdateret: for cirka 24 timer siden

Beskrivelse

Bemærk: Varen befinder sig i udlandet. Bemærk, at leveringsbetingelser, leveringstider og/eller købsproceduren derfor kan være anderledes.

If you load on an XL650 you have probably encountered the annoyance of spent primers bouncing off the Spent Primer Cup and ending up on your reloading bench or floor. The DAA XL650 Primer Output Tube Assembly puts an end to that problem by attaching directly over the spent primer exit window, and ensuring that spent primers have only one place to go – down the tube! The assembly is supplied with a 120cm (4ft) long PVC flexible tube, which will allow you to collect your primers in a container or bottle resting on the floor or attached anywhere under your press. he assemble includes:- A 120cm (4ft) long PVC flexible tube- A Delrin machined adaptor plate to fit to your XL650- Two longer 8-32 screws to replace the original ones on your Dillon Assembly Instructions:1. Remove your spent primer cup (part 16211) and spent primer cup bracket (part 16209) by unscrewing the two primer cup bracket screws (part 14689)2. Detach the PVC pipe from the adaptor. This makes it easier to assemble the adaptor. Pull the pipe firmly to detach3. Using the provided longer screws, attached the Delrin adaptor plate to the same mounting holes just vacated. Note that the part is directional – hold it so that the output hole lines up correctly with the exit window of the primers (the pipe mounting point will be on the side closest to you)4. Reattach the PVC pipe, and run it down to a collecting container. You can consider drilling a hole through your workbench to run the pipe vertically down This assembly is designed to fit current XL650 models. It will not fit units made prior to 1997. (if your 650 has the blue plastic Spent Primer Cup – it is current and will fit)