Achtung: Din browser er forældet. Bemærk, at dele af Gunfinder derfor ikke vil fungere. Du bør opdatere din browser så snart som muligt. Læs mere her!

GEISSELE AR15/M4 Gas Block Roll Pin Punch Set

≈ 321 kr
Pris hos forhandleren: 42,90 €. Omregnet efter ECB-kursen fra 30. oktober 2026.
8700 Leoben, Østrig
3
ID: 10090123
Køb fra et land uden for EU: Våbnet går gennem en importør i dit land, og forhandleren sørger for eksporten. Sådan foregår køb fra Europa
Køb sikkert med Gunfinder
Vores AI-baserede identitetskontrol af sælgerne gør Gunfinder til den sikreste markedsplads på nettet. Læs mere
Om sælgeren
Earms
Forhandler

Detaljer

Originalsprog
Tysk
Kategori
Stand
Ny
Placering
🇦🇹 8700 Leoben, Østrig
Tilgængelighed
ukendt leveringstid

Aktualitet

Dette tilbud er en kopi, hvor tilbudsdata er blevet overført til os fra en webshop, forhandler eller ekstern markedsplads. Bemærk, at eventuelle forsinkelser i dataoverførslen kan medføre midlertidige prisforskelle.
Kilde
Earms
Senest opdateret
for cirka 11 timer siden

Beskrivelse

Bemærk: Varen befinder sig i udlandet. Bemærk, at leveringsbetingelser, leveringstider og/eller købsproceduren derfor kan være anderledes.
The Geissele Gas Block Roll Pin Punch Set is made specifically for the removal and installation of the 0.078" roll pin that secures the gas tube to the gas block of an AR-15/AR-10. Removal of a rusted-in gas block roll pin has always been a challenge since there are no commercial pin punches in 0.078" diameter. Additionally, 1/16" (0.062") punches have a tendency to bend and very few starter punches are available in 1/16" diameter. The Geissele Gas Block Pin Punch Set makes gas block work a whole lot easier. The first punch to grab when removing the roll pin is the Starter Punch. This is the punch with the long, tapered end. The long taper is much more resistant to bending and buckling than the straight shank of the Pin Punch. Use the Starter Punch (Not included) to get the roll pin moving. Then, use the Pin Punch to drive the roll pin out completely. The Geissele Gas Block Pin Punch Set is made from properly hardened and tempered 01 tool steel. The Gas Block Pin Punch Set is considered a consumable item, meaning they will eventually wear out and will need to be replaced. Geissele will not replace tools damaged from misuse or normal wear and tear. Always make sure your weapon is unloaded and the magazine removed before starting work. Spec: This tool is designed to punch a 0.078” diameter roll pin in or out from a gas block Compatibility: Compatible with AR-15/AR-10 0.078” diameter gas block roll pins Note: Use the Gas Block Roll Pin Starter Tool to get the roll pin moving (SKU: 10-225) MADE IN THE USA