Achtung: Twoja przeglądarka jest przestarzała. Z tego powodu Gunfinder może nie działać poprawnie w niektórych miejscach. Jak najszybciej zaktualizuj przeglądarkę. Dowiedz się więcej!

Sprężyna magazynka rurowego – FACTORY Innovatac COMPS teleskopowa sprężyna magazynka

≈ 110 zł
Cena u Dealera: 25 €. Przeliczono po kursie EBC z 16 listopada 2026.
Dostępne od 18 lat (bez pozwolenia)
42100 Jämsä, Finlandia
0
ID: 11409137
Zakup spoza UE: Broń przechodzi przez importera w twoim kraju, a sprzedawca zajmuje się eksportem. Tak przebiega zakup z Europy
Bezpieczne zakupy z Gunfinder
Nasze weryfikowanie tożsamości sprzedawców wspierane przez AI czyni Gunfinder najbezpieczniejszym marketplace'em online. Dowiedz się więcej
O sprzedającym
Aawee
Sprzedawca

Szczegóły

Język oryginalny
Fiński
Kategoria
Stan
Nowe
Lokalizacja
🇫🇮 42100 Jämsä, Finlandia
Dostępność
dostępny

Aktualność

Ta oferta pochodzi z synchronizacji danych, podczas której informacje o ofercie zostały przesłane do nas ze sklepu, sprzedawcy lub zewnętrznego marketplace'u. Pamiętaj, że ze względu na możliwe opóźnienia w przesyłaniu danych mogą wystąpić tymczasowe różnice w cenach.
Źródło
Aawee
Ostatnio sprawdzono u sprzedawcy
około 20 godzin temu

Opis

Uwaga: Przedmiot znajduje się za granicą. Pamiętaj, że warunki dostawy, czas wysyłki i/lub procedura zakupu mogą się różnić.
COMPS telescopic magazine spring

Description:
COMPS is a magazine spring family engineered for competition shotguns.

COMPS telescopic magazine spring is designed to fit most available telescopic tubes. The geometry of the spring will reduce tube sticking and maximize the telescopic capacity.
Depending on the original setup, total capacity increase up to 5% can be achieved with optimal COMPS spring combination.
What this means is that you could be able to fit that one extra shell without sacrificing reliability. Or use longer springs for added reliability for your magazine system.
This spring will allow you to tune your telescopic system for function and capacity. And also be a high quality general spare spring for all systems.

Recommendation is to use a spring setup, that will start the telescopic expansion when the inner tube is 100% full (typically 10 shells). 
Using this recommendation will keep the telescopic system from expanding unnecessarily, keep it short and keep it clean as possible.
Minimum recommended setup is when telescopic expansion starts at 90% full (typically 9 shells).
Note: the spring is most likely tighter fit during assembly than the orginal spring. This is OK, and it is designed that way.
The diameter and clearance of the spring increases when compressed.

Specifications:

Length 760mm
High quality steel spring wire
Fits all known telescopic tubes (inner tube diameter up to 26mm) 

Podobne oferty