STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU, imagen 1 de 3

STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU

39,90 €

De libre adquisición (a partir de 18 años)

8700 Leoben, Austria

ID: 10089587

Compra seguro con Gunfinder

Nuestra verificación de identidad impulsada por IA hace que Gunfinder sea el marketplace más seguro online. Más información

Sobre el vendedor

Earms

Vendedor

3.748 anuncios

Detalles

Idioma original

Alemán

Categoría

Estado

Nuevo

Ubicación

🇦🇹 8700 Leoben, Austria

Disponibilidad

plazo de entrega desconocido

Actualidad

Esta oferta se basa en una sincronización de datos, mediante la cual la información de la oferta se ha transferido a nuestra plataforma desde una tienda, distribuidor o marketplace externo. Ten en cuenta que pueden producirse diferencias de precio temporales debido a posibles retrasos en la transferencia de datos.

Fuente: Earms
Última actualización: hace aproximadamente 12 horas

Descripción

Nota: El artículo se encuentra en el extranjero. Ten en cuenta que las condiciones de entrega, los plazos de envío y/o el proceso de compra pueden variar.

The Strike Industries AR Mil-Spec Buffer Housing gives the user a cost-effective means of customization while retaining functionality. The AR-15 buffer is often an overlooked part of the gas system that is needed to properly fine-tune your specific setup. This buffer housing is machined from 6061-T6 aluminum and designed to fit Mil-Spec standard or carbine length receiver extensions/buffer tubes while also providing a level of customization. The SI AR Mil-Spec Buffer Housing is shipped without weights so that you can either replace your current housing, use existing weights or opt to purchase weights to refine the weapons gas system to your specific needs. The NBR rubber material buffer pad helps absorb impact and is secured by the included roll pin. By modulating the weight through the combination of tungsten, steel and aluminum weights, the user is given a cost-effective means of adjusting the weapons reciprocating mass, and thus the recoil experienced by the shooter with the Strike Industries AR Mil-Spec Buffer Housing. COMPATIBILITY:-14mm (0.55") diameter Mil-Spec buffer weights and spacers (maximum of 14.20mm)-Mil-Spec standard and carbine length receiver extensions/buffers NOTE:-Buffer housing only, no weights or spacers included-Due to numerous factors that take place during the anodization process, the color lines from batch to batch of a certain product may vary -LENGTH: 83.15 (with buffer pad)-WIDTH: 25.25mm (curve to curve)-HEIGHT: 24mm (flat to curved)-WEIGHT: 1.0 oz-WEIGHT W/ PKG: 1.2 ozMONTAGEVIDEOMADE IN THE USA

Imprimir