AIRSOFT price negotiable - Plum handguard for toy Krinkov (AKS-74u) // LCT Cyma Cybergun/ Co2 GBB S-AEG / AKSU / Polymer plum / Softair

Airsoft component modeled after the Ribbed Polymer Plum Handguard from Arsenal Inc. If you're interested in multiple pieces: I actually have three available.Surprisingly stable,  pleasant, grippy handling, great optics. The material is nylon-polymer in a subtly grayish, slightly muted plum color.Fits, as far as I could find out, into the LCT as well as Cyma and very likely also into the Cybergun Krink. If there are any doubts - feel free to compare measurements (see Technical) !I had ordered it as a trial for a Yunker Co2 AKS-74u, but the upper handguard did not fit properly into the gas tube of the Yunker (see Technical section).If this part fits your airsoft - it would indeed be a recommendation!TechnicalThe lower handguard fit wonderfully and snugly into the Yunker Krinkov. It should also pose no problems with other airsoft Krinkovs.The upper handguard, however, is not suitable for every model. Here are the reasons:Normally, the mounts of a real upper handguard are constructed like two semicircles that run around the same axis (the gas tube), with the rear semicircle having a larger diameter than the front (the upper handguard narrows towards the front). The E&L, for example, is said to be relatively close to the original, meaning the mounting grooves from the gas tube are wider at the back and narrower at the front. However, many Asia airsoft Krinkovs have these semicircles symmetrically constructed, most likely to greatly simplify production.This upper handguard here is indeed symmetrically constructed: It has the same dimensions at both ends. Therefore, it does not fit correctly into a real gas tube, into a Yunker gas tube, or into an E&L gas tube. If you install it, for example, in an E&L gas tube, it has a strong inclination and does not run parallel to the lower handguard.If both ends of the upper handguard on your rifle are also the same, the upper handguard should fit well or be slightly adjustable. For comparison, I measured the parts:A) Upper handguardOverall length including mounts: approx. 106 mmLength of the grip area without the mounts: approx. 77mmWidth of the mount outside: approx. 28mmHeight of the mount outside: approx. 21 mmB) Lower handguard:Usable width for housing: approx. 34-35mmHeight of the rectangle that goes into the housing: approx. 11mmOverall length, including front mount to the actual start of the housing: approx. 120mmNotes:If there are any uncertainties, feel free to check the measurement instructions (the last 5 images).Material-wise, most likely unsuitable for real firearms. Shipping costs DHL €6.20 insured or €4.20 uninsured Within the EU: €14.50 insured or €7 uninsured