AKAH thermal imaging target pads

AKAH Thermal Imaging Target Pads With the AKAH thermal target pads, you have the opportunity to optimally adjust or calibrate your thermal imaging device. The handling is incredibly simple. Remove the thermal pad from the package, peel off the film on the back, and stick it to a suitable target. You can now make the settings on your thermal imaging device. The thermal pad reacts immediately after unpacking with the surrounding air and warms up to about 40° Celsius in no time. This reaction lasts for about 60 minutes, depending on the ambient temperature. The diameter of the adhesive surface is approximately 60 mm, and the heat-active area measures about 50 mm. The heat adhesive pads are double airtight packaged. Additionally, the outer packaging protects the pad from UV and sunlight exposure with a special coating. Application: Remove the heat adhesive pad from the packaging and remove the film from the adhesive surface. Then stick the thermal pad onto the respective target. Caution: The thermal pad activates upon contact with air. Please also observe the instructions on the back. Safety instructions 1. Only use for the intended purpose. 2. Avoid contact with skin. 3. Keep out of reach of children. 4. Dispose of properly after use. Ingredients: Iron powder, vermiculite, activated carbon, water, and salt. 1 box, contents: 10 pieces.