COP COP Relief Pad for Duty Belt Molle Adapter Hook Velcro - XL/XXL

The Cop relief pad for duty belt Molle adapter hook-and-loop ensures that the belt adapts even better to the anatomy of the wearer. The diameter at the lower end of the belt is larger, and the pressure on the hip bones is significantly reduced. The padded relief/intermediate belt has no buckle. It is equipped with Molle loops on the outside and hook-and-loop on the inside, along with additional mesh fabric. This allows you to secure it to an inner belt with loop velcro. The advantage is that you can continue to use your existing duty belt, as it is threaded through the Molle loops (the tunnel is suitable for belts up to 60 mm wide). Belt holders are attached at both ends of the belt to further secure the duty belt. When removing the system, the relief pad/Molle adapter usually remains on the duty belt. The connection with the inner belt is made via a loop velcro inner belt. You should choose the size of the intermediate belt so that it does not overlap under the buckle of the outer belt, but always leaves a gap. If the duty belt is threaded in front of the Molle loops at some points, you can thread holsters onto the duty belt. This gives you a combination of Molle loops and duty belt. Sizes: - M/L = six sections with three loops and three Molle rows each, minimum 90 cm hip circumference. - XL/XXL = eight sections with three loops and three Molle rows each, minimum 112 cm hip circumference.