KNS PRECISION AR15/M16/AR10 Gen2 Non-Rotate Trigger/Hammer Pin Kit .1555 Diameter

Non-rotating .1555 !Oversized! trigger/hammer pin set which are designed to sit flat against the side of your AR-15/AR-10 receiver. Toughest pins produced. Designed to withstand the stresses generated by high-impact suppressed fire. Trigger & hammer pins are stainless steel and retainer side plates are steel with a black nitride finish. KNS non-rotating trigger and hammer pins are the STRONGEST pins that can be produced and are designed to withstand the high impact of full and semi-auto 9mm, 5.56, and 7.62mm suppressed weapons. KNS non-rotating trigger/hammer pin sets prevent wear on your AR lower and prevent your pins from walking out of your receiver. Kit includes an installation guide tool & 2 Torx wrenches. No permanent modification to your gun is required. Torque spec for screw-tightening should not exceed 11 inch-lbs, 8 inch-lbs is recommended. IMPORTANT NOTE: The external width of some AR receivers may vary in the trigger/hammer pin area depending on the manufacturer. The pins being slightly too long will not affect the function or performance. FEATURES: Anti-walk/rotation Fits standard USGI diameter pin receivers with Oversized pin holes Material Trigger & Hammer pins: Stainless steel Material Side plates: Steel with black nitride finish .1555” / Oversized diameter COMPATIBILITY: AR-15/AR-10 Lower receiver with oversized diameters Does NOT fit Heckler & Koch or Haenel models MADE IN THE USA